Products

COMPACT, ECONOMICAL IN-HOUSE LAMINATOR
WHAT IS FILM LAMINATION?
Most types of thin plastic film, including cellulose acetate, oriented polypropylene, polyester and P.V.C., Reel fed and adhesive bonded to paper or board.

PRINT FEEDING
Sheets of Printed matter are fed continuously to the laminating station by hand fed on the conveyor table. An adjustable underlap of sheets is accurately maintained at all lamination speeds. A self-adjusting head allows for wide variations of thickness in the print stock.

FILM AND ADHESIVES
Solvent type adhesives are normally used. The film is fed from an adjustable unwind shaft through a reverse roller coating head fitted with adjustable roll. The film fed can be raised from the coating roller without stopping the machine. The adhesive is continuously circulated and filtered on each return cycle to the reservoir.

LAMINATION
The adhesive coated film is dried by passing over the heating chamber thermostatical controlled and by blown hot air. The film bonded to the printed sheets between the chromed steel and rubber laminating pressure rollers.

DELIVERY
Delivery of finished lamination is through the back of the laminator to rewind shaft. Sheet may be separated immediately if desired.

ELECTRIC CONTROLS
Electric Controls are housed in a neat desk mounted unit easily controlled by operator.

MAINTENANCE
Maintenance is minimum and access to all parts of the machine is quick and simple. Window doors at the front and rear of the film lamination machine allow full visibility during operation.

SPECIFICATIONS

Maximum laminating width	600 mm (24 inch) X any length
Speed	0-1800 ft/hours
	0-900 m/hour
Electrical equipments	1 H.P. 3 Phase/ single phase for drive
Power Load	1.74 KW
Film Roll width Roll Diameter	Max. 600 mm (24 inch) Max. 300 mm (12 inch)
Overall dimension	1800 mm L X 1500 mm W X 1950 mm H
Weight	1000 Kg.
Available Sizes	30 Inc., 36 Inc. & 42 Inc.